McAfee M4050 - Network Security Platform Guide de l'utilisateur télécharger pdf (Page 28)

Connect the other end of the Console cable directly to a COM port of the PC or terminal server you

will use to configure the Sensor, for example, a PC running the correctly configured Windows

HyperTerminal software.

You must connect directly to the console for initial configuration. Required settings for

HyperTerminal are:

Name Setting

Baud rate 38400

Number of bits 8

Parity None

Stop bits 1

Flow Control None

Power on the Sensor.

Cable the Auxiliary port

The Auxiliary port is for modem access to the Sensor for setup and configuration. You cannot use a

modem the first time you configure a Sensor.

Task

For modem connections, plug a straight-through modem cable into the Auxiliary port.

This port is labeled as Aux on the Sensor front panel.

Connect a modem to the Aux port.

Connect a telephone line to the modem.

Required settings for the Aux port are:

Name Setting

Baud rate 38400

Number of bits 8

Parity None

Stop bits 1

Flow Control None

Connect the cable to the Response port

When operating in tap or SPAN mode, the Sensor uses its Response port to respond to attacks. When

deployed in tap mode, the Sensor does not inject response packets through the tap but uses the

Response port.

Task

Plug a Cat-5e Ethernet cable into the Response port.

This port is labeled Rx on the Sensor front panel.

Connect the other end of the cable to the network device such as a hub, switch, or a router,

through which you want to respond to attacks.

Attaching Cables to the Sensor

Cable the Auxiliary port

McAfee

Network Security Platform M-3050/M-4050 Sensor Product Guide

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 41 42

Pas de commentaire

McAfee M4050 - Network Security Platform Guide de l'utilisateur Page 28