McAfee M4050 - Network Security Platform Guide de l'utilisateur télécharger pdf (Page 20)

Install the rails and ears on the chassis and rack

Before you begin

Before you install the rails and ears on the chassis, make sure that the power is off.

Remove the power cable and all network interface cables from the Sensor.

Each rack-mounting rail and ear has holes that match up with holes in the chassis. You will need a

screwdriver to secure the slotted panhead screws.

Task

Verify that you have all the parts you will need — two three-in-one rails, two chassis ears, and

fourteen slotted panhead screws.

Each rail includes a rail that mount to the rack, a rail that slides into the mounted rail, and a rail

that is attached to the chassis.

Disassemble the slide rail by pulling the inner rail out and pushing the side latch in to separate.

Attach the inner rail to the chassis by fastening it with the screws provided.

Attach the ear to each side of the chassis.

Mount the L-shape and external rail to your rack frame.

The adjustable end of the L-shape rail is intended for placement at the back of your rack. Adjust

the rail as needed for length. You are now ready to mount the Sensor on the rack.

Mount the Sensor on a rack

McAfee recommends rack-mounting your Sensor. The rack-mounting hardware included with the

Sensor is suitable for most 19-inch equipment racks and telco-type racks. For maintenance purposes,

you must have access to the front and rear of the Sensor.

Before you mount the Sensor on the rack, make sure that the power is off. Remove the power cable and

all network interface cables from the Sensor.

Due to the weight of the appliance, McAfee recommends that two people place the chassis into the rail

cabinet.

Insert the chassis into the rail cabinet and complete the rack-mounting of the Sensor by securing the

rack mount ears to two posts or mounting strips in the rack. The ears secure the Sensor to two rack

posts. Make sure to fasten the ears securely to the rack.

Optionally, you can also mid-mount the Sensor. For details, refer to the corresponding Sensor McAfee

Network Security Platform Quick Start Guide.

Remove a Sensor from the rack

Review this section if you need to remove a Sensor from the rack.

Setting up the Sensor

How to position the Sensor

McAfee

Network Security Platform M-3050/M-4050 Sensor Product Guide

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 41 42

Pas de commentaire

McAfee M4050 - Network Security Platform Guide de l'utilisateur Page 20