McAfee M-1250 - Network Security Platform Guide de l'utilisateur télécharger pdf (Page 19)

Attaching cables to the Sensor

Follow the steps outlined in this chapter to connect cables to the various ports on your M-1250/

M-1450 Network Security Sensor.

Note the following cabling specifications for the Sensor:

• Category 5 Enhanced (Cat 5e) cable is required for transmission speeds up to 1 Gigabit per second

(Gigabit Ethernet).

• For Ethernet networks running at 10 or 100 Mbps, Category 5 (Cat 5) OR Cat 5e cable can be used.

Throughout this guide, cabling specifications is mentioned as Cat 5/Cat 5e.

Contents

Cable the Console port

Cable the Auxiliary port

Connect the cable to the Response port

Cable the Management port

Cable Monitoring ports

Cable the Sensor to monitor in in-line mode

Cable the Sensor to monitor in SPAN or hub mode

About connecting Sensors for fail-over

Cable the Console port

The Console port on the Sensor is used for setup and configuration of the Sensor.

Task

For console connections, plug the DB9 Console cable supplied by McAfee into the Console port on

the Sensor.

This port is labeled as Console on the Sensor front panel.

McAfee

Network Security Platform M-1250/M-1450 Sensor Product Guide

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 29 30

Pas de commentaire

McAfee M-1250 - Network Security Platform Guide de l'utilisateur Page 19