McAfee FIREWALL 2.1-GETTING STARTED Guide d'installation télécharger pdf (Page 105)

105

Configuring the Engine in the Engine Configuration Wizard

Configuring the Network Interfaces

The Engine Configuration Wizard can automatically detect which network cards are in use. You

can also add interfaces manually if necessary. If the list is not populated automatically, you can

launch the autodetect as explained in the illustration below.

 To add the network interfaces

 Highlight Autodetect and press Enter.

Check that the detected drivers are correct and that all interfaces have been detected.

Defining the Network Interface Drivers Manually

 To define the network interface drivers manually

1. Highlight Add and press Enter.

2. Select a driver that is used for your network card(s) and press Enter.

What’s Next?

 If there are problems, add the network interfaces manually as explained in Defining the

Network Interface Drivers Manually.

 Otherwise, proceed to Mapping the Physical Interfaces to Interface IDs (page 106).

What’s Next?

 Repeat as necessary, then map the interfaces to Interface IDs as explained in Mapping

the Physical Interfaces to Interface IDs (page 106).

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 165 166

Pas de commentaire

McAfee FIREWALL 2.1-GETTING STARTED Guide d'installation Page 105